Concrete cutting in Castle Rock CO - clean cuts with the right saw for the job
Need an opening in a basement wall, a trench in a slab or a bad section removed? We cut it straight and leave it clean.
How do I get a concrete wall or slab cut in Castle Rock?
Concrete cutting in Castle Rock means sawing straight lines through a slab or wall, or core drilling round holes for pipes, drains and conduit, so you get the opening you need without busting up more concrete than the job calls for.
Most calls start with something you want to get through the concrete, like a basement window, a drain line under the garage floor, or a cracked section that has to come out before anything gets fixed. The price moves with how thick the concrete is, how much steel rebar runs through it, whether it's a wall or a slab and how easy the spot is to reach. The schedule usually waits on two things, whether a permit is needed and, for a wall opening, how big the steel over it has to be. Your estimate spells out what's included, so you can see where the money goes before anyone pulls a cord.
How we handle concrete cutting
Cutting comes down to the right saw for the spot, so I start by asking where the cut is, how thick the concrete is and whether it's indoors. A flat saw rolls along a slab, a wall saw runs on a track bolted to the wall, a hand saw gets into tight corners, a wire saw handles thick or heavily reinforced sections, and a core drill makes the round holes. Inside we use electric or hydraulic saws instead of gas, because a gas engine fills a basement with carbon monoxide and people have died from exactly that. We cut wet, with water running to the blade to keep the dust down, and vacuum up the slurry, the gray mud the cutting leaves, as we go so it doesn't get tracked through the house.
A cut is usually the start of something else. If you're taking out a broken run so we can pour a new concrete driveway, or opening a back wall for a door out to a new concrete patio, the cutting and the pour go on one estimate. Clean, square edges are what let new concrete meet the old without a ragged seam.
Permits and concrete cutting work in Castle Rock
The Town of Castle Rock wants permits submitted and approved before any site or building work begins. To apply for a building permit there, a contractor needs a valid license from a jurisdiction that requires an ICC-equivalent exam, the national building code test, plus liability insurance, workers' comp where it applies and a current registration with the city. Whether your particular cut needs a permit isn't something I'll guess at. We ask the office that covers your address, and if one's needed, we handle it before the saw comes out.
A lot of the cutting we get called for here is in basements, for egress windows and doors, and at driveways and patios where a cracked or heaved section has to go. Freeze and thaw works on the ground under a slab all winter, so before I cut out a bad piece I look at why it failed, because a patch on the same bad base cracks the same way. We see the same jobs in Castle Pines and Parker and handle them the same way.
How concrete cutting works
Call us or send the form
We get back to you and set a time to look at the job. Tell us where the cut goes, roughly how long it is and whether it's indoors, so I know what I'm walking into.
I measure and write it up
I come out, measure, check the thickness and ask what's in the concrete and what it's holding up. The estimate lists what's included, from the saw we'll use to the cleanup, so you can see how the price adds up.
Permits and closures come first
If a permit is needed, we handle it with the right office before work starts. If the cut closes a lane or sidewalk, the application and a traffic control plan go to the city's traffic engineer at least a week ahead, and a full street closure needs 21 days, so that sets the earliest start.
We cut and clean up
Our crew sets up the saw, cuts wet and vacuums the slurry as we go. If we pour new concrete afterward, you get plain notes on curing, the wait while it hardens before you use it, and on first winter care.
Get an on-site estimate for your cut and the work around it
We reply within one business day to set a time, and the on-site estimate is free with no pressure to book. I come out, measure, ask what's in and around the concrete, then write up an estimate that lists what's included.
What people ask before a concrete cut
How much does concrete cutting cost per foot?
Professional concrete saw cutting across the US usually costs about $4 to $25 per linear foot. Reinforced or deeper slabs and wall sawing cost more per foot than cuts in thin, easy-to-reach slabs, and on a small job the minimum or setup charge can set the bill more than the footage does. Your estimate shows how it adds up for your cut.
How do I cut an opening in a basement wall for a window?
Before anyone cuts, you get the size of the steel angle lintel, the steel piece that bears on each side of the opening and carries the wall above, from a structural engineer or the lintel supplier. Its size depends on the load above and how thick the wall is. I'd rather wait on the engineer than guess about what's holding up your house, and once that's settled the cut is the easy part.
How do I check that a concrete contractor is registered in Castle Rock?
Search for them in the city's eTRAKit Development Portal, which the city's hiring a contractor page points owners to. Castle Rock makes it unlawful to do construction, repair, removal or demolition work on the buildings and structures its code governs without registering with the city first, so it's worth checking before you sign anything.
Who cleans up the slurry after concrete cutting?
The crew doing the cut should, and you want that settled in the quote, so ask upfront whether the slurry will be vacuumed and contained. Wet cutting keeps the dust down but makes plenty of slurry, and raw slurry running into a storm drain is an environmental violation in many areas. Ours is written into the estimate.
Do I need to call 811 before digging out a cut section of concrete in Colorado?
Yes, Colorado law requires anyone doing an excavation to contact 811 first to learn where underground lines run in the project area. Once a slab is cut and broken out, digging under it is excavation, so that call gets made before anyone picks up a shovel.
Can I cut out a cracked section of my driveway instead of replacing all of it?
Often, yes, if the rest of the slab is sound and the crack came from one bad spot rather than the whole base settling. We saw the edges straight so the new piece meets the old cleanly, then dig out and pack the base under it before the pour. If the subgrade, the dirt the slab sits on, is the problem everywhere, a patch just cracks again, and I'll tell you that at the estimate instead of letting you find out next spring.
Why Castle Rock homeowners call Prestige Castle Rock Concrete for cutting
I see the cut before quoting
I come out to see the job and do the estimate myself, and I look at what's in and above the concrete before I put a price on it. You're talking to the person who answers for the work, not getting a guess over the phone.
Learned on my dad's crews
I grew up working flatwork and footings on my dad's crews and started this business in 2023 so I could run jobs my own way. I know what's usually under a slab and how a bad base shows up later, which matters when you're deciding what to cut out.
Licensed and insured, just ask
We're licensed and insured. It's a fair thing to ask about before anyone runs a saw through your basement wall.
Based here, working nearby cities
We're based in Castle Rock and work across the cities around it, so basement cuts and freeze-thaw cracks are the jobs we know. If your city isn't listed, call and ask.
On a cut, the expensive mistakes happen before the blade starts, so the time goes into knowing what the concrete carries and what's under it. Tell us about your cut and I'll come take a look.
Work that often follows a cut
Concrete driveway building
If the cracked or heaved section is most of the driveway, a full replacement with a dug-out, packed base usually beats patching around the damage year after year.
Concrete patio construction
Cutting a new door through a back wall is a good time to plan the patio it opens onto, sloped so water runs away from the house.
Plan your cut and the concrete after it
Call (720) 676-1126, use the contact form or email team@concretecastlerock.com with where the cut goes, about how long it is and whether it's indoors, and I'll show up knowing which saw to bring.
